Die Casting

Die-casting mould is made form steel and similar as permanent mold casting, suitable for aluminum alloy, zinc alloy and copper alloy. The thickness of die cast part is mini 2mm, the draft angle of die cast is 0.5º. The finish of die casting is better than sand casting.

The machine is made up of two vertical platens. One platen is fixed and other is moving, can open and closed. When the melted material is poured into the shot sleeve, the shot sleeve will push the melted material into the mold cavity. After the material is solidified, the moving platen will be open, then remove the product.

The mould cost is much higher than sand casting mould, so the die casting process is economical only for high production.


Post time: Dec-10-2019